UV Steriliser and Spares

Chemical Free Water Treatment

Use our UV treatment to remove the bugs and bacteria instead of adding chemicals to your water tank or water supply, a great alternative to chlorine

Service and Maintenance

This can be done DIY, the bulb(s) needs to be replaced annually or every 12 months, there effectiveness reduces with time, while the bulbs are designed to run for 18 months their effectiveness is less after the 12 month period.

Important: Never Look at UV light when on!!! 

To Service follow these easy steps:

1. Turn off the electricity
2. Turn of the water and drain the system by opening tap or drain plug on some models
   
3. Carefully remove the plastic bulb cap and slide the bulb out a little, holding the end of the bulb remove the electrical plug
4. Remove the bulb carefully
5. loosen and carefully remove the two nuts on the ends of the UV can, careful not to loose o-rings
6. Remove and store o-rings in safe place
7. Carefully remove the uv tube
8. Clean the UV Quartz Tube with some water and a gentle cloth replace if any permanent damage
9. Slide the clean Quartz Tube back into the UV Unit having an equal amount of tube each end excluding the radius end bit (so the o-ring can rest on the solid the not the rounded end.
10. Slide on o-rings (replace if perished - every 3-4 years)
11. Gently tighten nuts back on by hand firm but not over tight
12. Slide in the the new UV Bulb
13. Reconnect wires
14. Turn on Water and check for leaks
15. Replace water plastic cap
16. Turn on Power again

Complete Models: